I finally got the rear body panel and curved inner panel, rumble stops, rumble stop braces and rear spare tire carrier brace installed today. This was the toughest fit so far. 39 holes had to line up exactly to bolt it together and since the riveting is done it was tight. But at the end of the day everything fit together.
After we got all the rivets in, the new bottoms of the quarter panels had to be crimped over the subrails and welded in place. Walt let me borrow his spotwelder which worked like a champ. Since the Roadster chassis is now running, I've had so many requests for rides that today I added an extra seat for any brave soul that wants a ride!
Burned up the neighborhood today in the hot roadster! The neighbors took the pictures. So much fun.
Harry finally finished his house project so he could come over and help finish the riveting. I had the body back together with tiny bolts waiting until he could come over and help rivet. One of us has to buck the rivet and the other one run the gun so we swap off a lot. I took all day but we finished her up, then took it off the dolly, stood her on her nose and sanded and primed the bottom panels and riveted parts. A good day thanks to Harry!
I'm getting closer to test drive time and I needed some way to support a gas tank, radiator, the temporary steering column, the coil and wiring and choke rod. Then I remembered I had a spare cowl on the trailer in the back yard so I installed it today. Radiator is now supported, steering column supported, choke rod installed. I will put new gaskets and float on my gas tank and install it in the cowl and I can check out the tank before paint to be sure it doesn't leak. Tomorrow I will get new battery cables and coil wiring done. Walt gave me new spark and gas rods so they are installed also. More tomorrow.
Today I got finished with the brakes.
The first picture is the service brake and emergency brake cross shafts and arms installed with the brake rods.
The next picture is the brake rods going to the rear wheels, one is service brake and the other rod is emergency brake. You can also see the brake return springs attached to the rods.
Third picture is the battery installed in the car and the pedals and linkage around it. As you can see there is a lot there and that is why I waited to get the body together before I put the running gear in or I would have had to try and rivet around it all.
The car didn't have emergency brakes when I got it. Walt gave me a brake handle and I fabricated the bracket to attach it to the transmission and all the linkage to hook it up. The next picture shows the linkage attaching the hand brake and the support for it. You can also see the brake light switch coming out of the crossmember on the drivers side.
The last picture shows it all together with the exhaust system and radiator in place. Next I have to do some temporary wiring and fuel system so I can test drive it.
When I got the overdrive and shifter in all looked good until I installed the brake and clutch pedals and linkage. Then I realized the model A bracket that comes with the overdrive won't work on a B model transmission. So after fabricating a bracket to hold the shifter, the shift arm was in the way of the brake rod. So after scratching my head a little I machined off part of the bracket and reversed the arm and had just enough clearance to work. So I installed the brake cross shaft and got ready to hook up the brake rods to each wheel. I also put in the battery box to see if I still had clearance. It's tight but it works!
